Fluorescent Light Tombstone Wiring

Click to see full answer.

Fluorescent light tombstone wiring.

T5 with instant start ballast. Herein how do you get a wire out of a headstone. Use one wire on each side of the tombstone this give you two tombstones each one having two wires attached. To get more detailed information on each product click on the product and scroll down the page and you will find a product description and additional information.

Series ballast wiring 1 to 3 lamps. Replace the shunted lamp holders or tombstones with a non shunted variety. Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube. Series ballast wiring 4 lamps.

Push the fluorescent fixture wire into the tombstone next to the paper clip. To remove the cover grab the cover on both sides and squeeze to release the cover from the fixture. Double ended t8 direct wire or ballast bypass most compatible with shunted and non shunted. Removing the ballast cover allows you to access the tombstones and the wiring.

Remove the light fixture cover from the fixture. Replace the tombstone in the fluorescent light fixture so your fluorescent tubes glow once again. Non shunted with external wire shunt t5 with rapid start programmed start or dimming ballast. Replace the tombstone in the fluorescent light fixture so your fluorescent tubes glow once again.

Using shunted lamp holders or tombstones when led retrofitting can damage the bulbs or the fixture itself. Wires from the ballast plug into push in connectors in the lampholders that connect to the pins of the lamp. Single ended t8 direct wire or ballast bypass non shunted. Series ballast lampholder wiring 2 and 4 lamps.

Parallel ballast lampholder wiring. 2 lamp instant start ballast wiring diagram using non shunted lampholders. Most covers snap on and off.